This dataset presents the raw data of an experimental series of analogue models performed to investigate the influence of inherited brittle fabrics on narrow continental rifting. This model series was performed to test the influence of brittle pre-existing fabrics on the rifting deformation by cutting the brittle layer at different orientations with respect to the extension direction. An overview of the experimental series is shown in Table 1. In this dataset we provide four different types of data, that can serve as supporting material and for further analysis: 1) The top-view photos, taken at different steps and showing the deformation process of each model; they can be used to interpret the geometrical characteristics of rift-related faults; 2) Digital Elevation Models (DEMs) used to reconstruct the 3D deformation of the performed analogue models, allowing for quantitative analysis of the fault pattern. 3) Short movies built from top-view photos which help to visualize the evolution of model deformation; 4) line-drawing of fault and fracture patters to be used for fault statistical quantification. Further details on the modelling strategy and setup can be found in Corti (2012), Maestrelli et al. (2020), Molnar et al. (2020), Philippon et al. (2015), Zwaan et al. (2021) and in the publication associated with this dataset. Materials used for these analogue models were described in Montanari et al. (2017) Del Ventisette et al. (2019) and Zwaan et al. (2020).
This dataset presents the raw data from two experimental series of analogue models and four numerical models performed to investigate Rift-Rift-Rift triple junction dynamics, supporting the modelling results described in the submitted paper. Numerical models were run in order to support the outcomes obtained from the analogue models. Our experimental series tested the case of a totally symmetric RRR junction (with rift branch angles trending at 120° and direction of stretching similarly trending at 120°; SY Series) or a less symmetric triple junction (with rift branches trending at 120° but with one of these experiencing orthogonal extension; OR Series), and testing the role of a single or two phases of extension coupled with effect of differential velocities between the three moving plates. An overview of the performed analogue and numerical models is provided in Table 1. Analogue models have been analysed quantitatively by means of photogrammetric reconstruction of Digital Elevation Model (DEM) used for 3D quantification of the deformation, and top-view photo analysis for qualitative descriptions. The analogue materials used in the setup of these models are described in Montanari et al. (2017), Del Ventisette et al. (2019) and Maestrelli et al. (2020). Numerical models were run with the finite element software ASPECT (e.g., Kronbichler et al., 2012; Heister et al., 2017; Rose et al., 2017).